|
FM2500 Series Automatic Swing Gate Opener
The GTO SW2500 Gate Opener will handle gates weighing up to 500 lbs. and up to 16 ft. in length. The PRO-SW2500 is a common selection for the basic residential gate application. Designed to address most chain-link, tubular steel, vinyl, wood, aluminum and ornamental gate applications.
|
Click here for bigger picture. |
Features of SW2500 Gate Openers
Easy to install low voltage system, no electrician or welding required.
COMMERCIAL GRADE Soft Start / Soft Stop feature increases life of hardware and opener.
Large control box with room for extra battery and accessories.
Works on all gates; chain link, tube, panel, ornamental, wood and vinyl.
Provides up to 225 cycles per day using transformer charger.
UL APPROVED - obstruction sensing enhances gate operation safety.
Adjustable gate activation alert and auto-close.
12-volt battery backup (included) opens and closes the gate even during power outage.
Designed for gates that open into or out from the property.
24 month Limited Warranty.
Solar compatible
|
| |
|
DRIVE
. Low friction screw drive (linear actuator) rated for -5 ºF to +160 ºF (-28 ºC to +71 ºC).
. Powered by a 12 V motor with integral case hardened steel gear reducer. Motor speed reduced to 260 rpm. Generates
680 ft. lb. of torque at 12 V.
. Maximum opening arc of 110º. Approximate opening time (90º): 20 seconds, depending on weight of gate.
POWER
. The system is powered by a 12 Vdc, 7.0 Ah, sealed, rechargeable lead acid battery.
. Battery charge is maintained by a 120 Vac input, 18 Vac output transformer rectified to 14.5 Vdc (40 VA) through the
GTO/PRO control board. One (1) blade-style control board fuse is rated for 25 A.
NOTE: The transformer should not be directly connected to any battery. Do not replace fuses
with higher ampere rated fuses; doing so will void your warranty and may damage your control board.
. Battery charge is maintained by a GTO/PRO Solar Panel Charger: float voltage of 14.5 Vdc output is from a 193/8" x
81/2" silicon alloy panel. Generates a minimum of 5 W at 300 mA. A gated diode on the control board prevents
battery discharge.
CONTROL
. GTO/PRO microprocessor-based control board is set for single leaf, pull-to-open gate installations. DIP switches
can be adjusted to accommodate an optional kit for push-to-open gates (see Accessory Catalog).
. Control board has temperature compensated circuits.
. A circuit on the control board regulates charging. "Sleep draw" is 40 mA; "active draw" is 2 to 5 A.
. Auto-memorization of digital transmitter code.
. GTO/PRO remote-mounted RF receiver tuned to 318 MHz.
. Opener length with push-pull tube fully retracted is 401/4", mounting point to mounting point.
. Adjustable auto-close timer, and obstruction sensitivity.
. Power terminal block accommodates a transformer or solar panels.
. DIP switches simplify setup of gate opener.
. Accessory terminal block is fully compatible with push button controls, digital keypads, safety loops, etc.
. Control board allows connection of safety edge sensors and photoelectric sensors.
. Audio entrapment alarm sounds if unit encounters an obstruction twice while opening or closing.
OPERATIONAL CAPACITY
. The Gate Capacity Chart shows approximate cycles, per day, you can expect from the GTO/PRO SW-2500 Automatic
Gate Operator when powered with a transformer. Actual cycles may vary slightly depending upon the type and
condition of gate and installation. |
| |
|
 |
| |
|
| Free Shipping on SW2500 Gate Openers - UPS Ground only within Continental U.S. [ conditions ] |
|
|
|
